Size darts are adjusted and saved on the hull front torso for miniature doll.Photo copyright 2010 Lesley ShepherdPins or tape your basic pattern pattern back on the front torso of your doll, leaving the closed side registered darts. Tape or PIN the ground belt Centre and tape or PIN side model along with the doll. If your doll has a pronounced cutting line, you create darts size to fit the adjustment of the bust.
To size a Doll shoulder darts - take additional materials on the belt of dolls and fold a jib point of its triangle at right angles to the point of the bust of DART. Make sure that you pull fabric from the point where the Centre of the pattern is saved or pinned to the size of the doll. You have to bend a DART each side torso doll size. Before you strip the folding DART in place, you can run on the side of your soft pencil on the folding size DART line to mark the two fold, and where the fold affects the rest of the fabric. When you have enabled the DART it Ribbon in place and mark the rest of the belt. Remove the doll, basic pattern without opening the bust or size darts. !(see next step). Remove the belt and verify the adequacy of the model database against the doll. Fix falling in the right place for a seam edges.
No comments:
Post a Comment